Supports breaking off at base | 3D Printing | Page 1

oak pier Aug 9, 2025, 2:12 AM

#

It happened to me twice, I thought that the initial layer height was too small so I went up to 0.15mm from 0.1mm. the support infill is also set to hollow I'm not sure if that plays a role.

ivory riverBOT Aug 9, 2025, 2:12 AM

#

oak pier It happened to me twice, I thought that the initial layer height was too small s...

#

AI Help

It's good that you increased the initial layer height, as that can help with adhesion. The support infill being set to hollow should not affect the initial layer adhesion. Make sure your print bed is properly leveled and clean, and consider adjusting the bed and nozzle temperature for better adhesion. If the issue persists, you might want to check the extruder calibration and filament quality.

stone sigil Aug 9, 2025, 2:21 AM

#

is the filament dry?

oak pier Aug 9, 2025, 2:35 AM

#

Yeah

#

I just opened it from the box

stone sigil Aug 9, 2025, 4:22 AM

#

just cause its new

#

dosnt mean its dry

#

dry yo filament

oak pier Aug 9, 2025, 4:46 AM

#

Kk will do

#Supports breaking off at base