#Strings/hair on build

1 messages · Page 1 of 1 (latest)

north flower
#

I had a similar issue earlier, it dissapeared and i got a new roll of filament and it started happening again, different brand and i fixed the new settings for the new roll.
Very spesific spots and doesnt happen anywhere else on the build.
Anyone have ideas to what is going on

granite citrusBOT
#
AI Help

It sounds like you may be experiencing inconsistent extrusion due to issues such as a clogged nozzle, improper filament diameter settings, or uneven filament spooling. I recommend checking and cleaning your nozzle, adjusting filament diameter settings in your slicer software, and ensuring your filament spool is unwinding smoothly. Additionally, double-check your printer settings to ensure they are optimized for the new filament brand. If the issue persists, consider reaching out to the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
robust raft
#

Dry your filament

north flower
# robust raft Dry your filament

its been dried? also seen alot of videos on wet/dry filament, and its almost never one spesific spot that is weird, it seems like the whole roll/build will be fucked up? no?

robust raft
#

You're getting strings where your seams are. You could also tune your seams

north flower
robust raft
#

yes, of course

north flower
# robust raft yes, of course

found an article on google, some people said it could be a retraction problem and that the filament keeps going out while its moving into the air, which would explain why there only are "whiskers" at corners or where walls meet, mby it tries to go in a straight line and moves out from structure but keeps fueling out filament, ill try drying once more and reducing max heat on printer, and getting better retraction and slower speed, thanks for help btw

#

also wasnt able to look at the print since i was out, ill have to babysit next print 🙂