Printer doesnt print in the center | 3D Printing | Page 1

grizzled ferry Aug 1, 2025, 12:56 PM

#

hi all, new to 3d printing. my printer is a sovol sv07 and when it prints it doesnt do it on the center, the bed leveling keeps failing and it seems one of the axis has a large amount of offset. can someone help?

fickle vineBOT Aug 1, 2025, 12:56 PM

#

grizzled ferry hi all, new to 3d printing. my printer is a sovol sv07 and when it prints it doe...

#

AI Help

It sounds like you may need to recalibrate or adjust the bed leveling on your SoVol SV07 printer. Make sure that all the axis are properly aligned and that the bed is correctly leveled. You may also need to calibrate the offset on the axis that's causing the issue. Refer to your printer's manual for guidance on how to do this. If you continue to have trouble, you may want to reach out to SoVol's customer support for further assistance.

cloud creek Aug 1, 2025, 2:11 PM

#

grizzled ferry hi all, new to 3d printing. my printer is a sovol sv07 and when it prints it doe...

https://www.klipper3d.org/Config_Reference.html#stepper you have to configure position_min and position_endstop correctly so your nozzle rests at the front left edge of the print bed at x0 y0

#

otherwise your slicer config and printer config don't match

#Printer doesnt print in the center