guys im having problem in slicer apps can someone help pls (using ender 3 neo)

[waxen horizon]

idk which settings to use i tried default but results was not rlly good

[willow patio]

AI Help

It's important to adjust your 3D printing settings based on the print material, model complexity, and desired quality. You can start by adjusting parameters like layer height, print speed, temperature, and flow rate. It may require some trial and error to find the optimal settings for your specific setup and model. Feel free to provide more details about your printer and filament so I can help you further.

WARNING: This response is AI generated and may contain errors.

How to get the best help!
To get the best help please provide as much of the following information as you can.

Printer
  - Make:
  - Model:
  - Any Mods:
  - Firmware: 
Filament
  - Material:
  - Brand:
  - Print Temp:
  - Bed Temp: 
Settings
  - Any relevant settings:
  - What Slicer are you using?:
Printer Health
  - Calibrated XYZ?:
  - Calibrated E steps?:
  - Calibrated Flow?: 
  - Calibrated retraction / Coasting?:
  - Have you hot tightened your nozzle?:
Any recent changes to:
  - The printer:
  - Slicer Settings:
  - Firmware: 
Troubleshooting
  - What are you trying to do?:
  - What is it not doing?:
  - What steps have you tried so far?:

?help_me requested by: m.von.d#0

[remote edge]

👆And pictures

[waxen horizon]

one sec

[waxen horizon]

i throw them but tomorrow i can print a benchy and send the photo