#Neptune 3 pro nozzle hitting print and knocking over

1 messages · Page 1 of 1 (latest)

surreal thunder
#

This goes beyond just scarring, the prints are being completely destroyed and they are being wiped from the print bed. I have enabled z hop, at 0.45mm at this point. I have adjusted leveling multiple times. I have enabled avoid print as well as avoid supports. No matter what I do, it continues to fail. At this point I am unclear whether it is a hardware or software issue. It will occasionally print a Buddha but, it will also mostly fail those. The higher it prints the more likely it is to fail.

exotic treeBOT
#
AI Help

It sounds like you are experiencing issues with adhesion and possibly calibration. Here are a few suggestions to try:

  1. Ensure that your print bed is clean and properly leveled. It's important to have a good first layer adhesion for successful prints.
  2. Try increasing the initial layer height in your slicer settings.
  3. Make sure your extruder nozzle is clean and free from any obstructions.
  4. Check if your print bed is properly heated to the recommended temperature for the filament you are using.
  5. Consider trying a different filament brand or type, as some filaments may require different settings for optimal printing results.

If the issue persists, it might be worth checking with the manufacturer of your 3D printer for further assistance.

WARNING: This response is AI generated and may contain errors.
surreal thunder
#

I am printing in PLA at 210° and the bed is heated to 70°

#

There are no mods

#

The firmware is exactly what it came with and I have altered nothing

haughty valley
#

Did you clean the print bed

#

Cause any print bed can deal with a good amount of force hitting the print if it is clean.
Next step would be z offset

surreal thunder
#

I did in fact clean the bed

#

And I have adjusted z offset

haughty valley
#

Did you use dish soap and water? I haven't had luck with isopropyl. Seems it just spreads the oils around

surreal thunder
#

Yep yep

surreal thunder
haughty valley
#

Z offset?

surreal thunder
#

Already tried

exotic treeBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

surreal thunder
#

Please help lol

haughty valley
#

Try a factory reset and a fresh profile on your slicer