First layer on bambu lab a1 | 3D Printing | Page 1

daring owl Jul 3, 2025, 11:03 PM

#

This is currently what my first layer looks like on my bambu lab a1. What can i do to improve it? (Noticed this just after a failed print where the print came loose)

viral lilyBOT Jul 3, 2025, 11:03 PM

#

daring owl This is currently what my first layer looks like on my bambu lab a1. What can i ...

#

AI Help

To improve your first layer adhesion on your Bambu Lab A1, you can try the following steps:

Ensure that your printer bed is level. Use a leveling tool or sheet of paper to adjust the bed height accurately.
Clean the build plate with isopropyl alcohol to remove any grease or residue that could be affecting adhesion.
Adjust your nozzle height to ensure proper squish of the filament onto the bed. It should be close enough to create a solid connection but not too close to scrape or prevent filament flow.
Increase the bed temperature if possible to help with adhesion.
Try using a brim or raft feature in your slicer software to provide better support for the print.

By following these steps, you should see an improvement in your first layer adhesion.

daring owl Jul 3, 2025, 11:18 PM

#

Here are some more pics of the first layer

daring owl Jul 4, 2025, 12:53 AM

#

Nevermind. Followed the steps below and found that the four screws were all loose.

viral lilyBOT Jul 6, 2025, 12:45 AM

#

Is your problem solved? / No longer need this channel?
You can close a help channel with ?solved when it is no longer needed.

#First layer on bambu lab a1