Voron bed mesh issue

[pine remnant]

Hello everyone , i have my voron trident 300 with a xol toolhead , beacon on mamoth gantry that give me Weird bed mesh .I tried few things advise by the voron discord , like playing with the Y extrusion to limit the low spot, check the beacon config and re do it , ....Also playing with the extrusion make the issue worth even more . i notice that on both side of the bed in the back that the nozzle isn't at the same height by a quite a bit too
Some thought it could be twist somewhere , but i don't know how to check that .I also run bed mesh with both methode from beacon contact(same as tap sensor ) and proximity (over the bed and get meusurement )
Does anyone know what could be the actual cause of this ?And how to fix this ?

[placid oxide]

AI Help

It sounds like you may be experiencing issues with bed leveling and nozzle height consistency on your Voron Trident 300. One possible cause of the uneven bed mesh and nozzle height discrepancy could be mechanical misalignment or twist in your printer's frame or components. To check for twist in your printer, you can try the following steps:

1. Check that all frame components are securely fastened and aligned properly.
2. Verify that the gantry and bed are level and parallel to each other.
3. Check for any play or slop in the linear motion components (rails, bearings, etc.).
4. Inspect the Xol Toolhead and beacon assembly for any signs of misalignment or mechanical issues.

If you have already attempted the suggestions from the Voron Discord community and are still experiencing issues, you may want to reach out to the community again for further assistance or consider seeking help from Voron support.

In the meantime, continue troubleshooting by ensuring that your bed leveling proce...

WARNING: This response is AI generated and may contain errors.