PLA+ Slicer settings

[fathom umbra]

Hello, printed on Creality CR-M4 with PLA+ from Jayo. 0.4mm nozzle.

Filament was just dried prior to printing.

0.18 Layer height
0.42 Layer width
50mm speed
0.7 retract
40 retract speed
0.1 z hop
0.9 Flow

Problems with smaller stuff (text, pillars) also with the big text ”3D printer test”. Ant suggestions?

Creality Print as slicer

[hushed acorn]

AI Help

It seems like you are experiencing issues with smaller details on your prints. Here are a few suggestions you can try:

1. Check your nozzle and make sure it's clean and not partially clogged. A partially clogged nozzle can affect the extrusion, especially with smaller details.

2. Ensure your bed leveling is properly done. Inaccurate bed leveling can lead to uneven first layers and affect print quality for smaller parts.

3. Try adjusting your retraction settings slightly. Play around with the retraction distance and speed to see if it reduces stringing on smaller features.

4. Experiment with lowering the layer height even more for finer details. If your printer can handle it, reducing the layer height can improve the overall quality of intricate features.

5. Verify that your filament diameter is correctly set in your slicer. Incorrect filament diameter settings can lead to under or over-extrusion issues.

6. Lastly, consider increasing the print speed for smaller details to allo...

WARNING: This response is AI generated and may contain errors.

[fathom umbra]

195* nozzle
60* bed