#Wall printing troubles

1 messages · Page 1 of 1 (latest)

stoic stone
#

I have a bambu lab a1 and I'm printing with petg with .12 layer height. The lines on the wall didn't print super well and there was a small layer shift at the top of the wall. Is there any thing I could be doing wrong?

20250617_185949.jpg
inland cipherBOT
#
AI Help

It sounds like there may be a potential issue with bed leveling or belt tension in the printer. Make sure your print bed is leveled accurately and the belts are tight. Also, check the printing temperature and speed settings for PETG. Adjusting these settings could also help improve the print quality.

WARNING: This response is AI generated and may contain errors.