#Anycubic Kobra 3 Horizontal lines

1 messages · Page 1 of 1 (latest)

lyric fractal
#

Hello! I have been having issues with my Anycubic Kobra 3 having a horizontal line across most of my prints. I have tried calibrating the gantry, cleaning and re lubing the z rods, changing my slicer and slicer settings, rescrewing things. When I tighten or loosing the wheels sometimes after it wont have the lines for one print then goes back to having the lines. My other printers have no problem with the exact same print jobs. It is almost like its over extruding for a few lines. Would anyone know what this issue is and how to fix it? Thank you in advance!

IMG_8070.jpg IMG_8071.jpg IMG_8014.jpg IMG_8013.jpg IMG_8012.jpg
boreal scaffoldBOT
#
AI Help

It sounds like you may be experiencing issues with over-extrusion or inconsistent layer heights on your Anycubic Kobra 3. Here are a few potential solutions to try:

  1. Check your extruder calibration: Make sure your extruder steps/mm are accurately set in your printer's firmware. You can find guides online on how to calibrate this for your specific printer model.

  2. Verify your filament diameter: Ensure that your slicer settings match the actual diameter of your filament. Using the wrong filament diameter can lead to over-extrusion.

  3. Clean the nozzle: A clogged nozzle can cause inconsistent extrusion. Try cleaning the nozzle by using a nozzle cleaning tool or performing a cold pull.

  4. Check your filament path: Ensure that the filament path from the spool to the extruder is smooth and free of any obstructions or tangles that could be causing inconsistent extrusion.

  5. Monitor your print temperatures: Incorrect print temperatures can also impact extrusion. Make sure your nozzl...

WARNING: This response is AI generated and may contain errors.
lyric fractal
#

Printer make and model: Anycubic Kobra 3
• Any Mods: No
• Firmware: 2.4.0.4
• Filament material and temps: PLA 215c Bed 65c
• Slicer: Anycubic next slicer
• Any recent changes: its a new printer
• What have you tried so far: cleaning z rods, tightening wheels, loosening wheels, rescrewing screws and bolts, new filament, new slicer settings, leveling, calibrating gantry, calibrating bed.