#Wiring Octopus Pro v1.0.1

1 messages · Page 1 of 1 (latest)

silk lichen
#

Confused on how to wire some parts, mainly the pt100/pt1000 what do I do with it? I am following a voron wiring guide even though im not using a voron, mainly to help me figure out where jumpers should go. What do i do with pt100/pt1000?

floral ridgeBOT
#
AI Help

The PT100/PT1000 sensor is a temperature sensor commonly used in 3D printers to measure the temperature of the hotend or heated bed. In most cases, the PT100/PT1000 will have two wires that need to be connected to the appropriate terminals on your 3D printer's mainboard for temperature monitoring. The exact wiring configuration may vary depending on your specific printer and mainboard.

Since you mentioned following a Voron wiring guide, it's recommended to carefully review the wiring instructions provided in that guide and adapt them to your specific setup. You can consult the wiring diagrams for Voron printers to determine the correct placement of jumpers and connections for the PT100/PT1000 sensor.

If you encounter any specific issues or need further assistance with wiring the PT100/PT1000 sensor, feel free to provide more details, and I can help guide you through the process.

WARNING: This response is AI generated and may contain errors.
unkempt basin
#

Circled in yellow. Top

silk lichen
#

I have the octopus pro

#

okay, I found what I needed, i was calling it wrong

#

but im still slightly confused

#

Its actually the DIP switch I was confused on. How do I figure out whice ones I need to set to on?

#

here is the octopus pro v1.0.1 pinout