Resuming failed print

[paper aspen]

Hey fam,

Was printing this on an Ender 3 pro with what I assume is stock firmware.

Thought I had enough clearance on the Z stabiliser for this print to finish but obviously not.

There was no error on the screen as attached, am I right in assuming the coordinate that it was locked to is where the print failed and can edit the g code to start from this position?

If not what would be my next best step? Hopefully not a 4d print down the drain.

I'm guessing I'll need to take the stabiliser off to finish the print if I can resume it successfully.

Thanks in advance.

[cerulean warren]

AI Help

It seems like your print failed due to a Z-axis shift. You can try to resume the print from where it left off by editing the G-code. Look for the last successful layer in the G-code and make sure the new code starts from that point.

If the print is salvageable, you may need to remove the Z stabilizer to allow the print to continue without interference. Remember to recalibrate and re-level your bed before resuming the print to ensure a successful outcome.

Good luck with salvaging your print! Let me know if you need further assistance.

WARNING: This response is AI generated and may contain errors.

[dapper pecan]

You might be able to resume by editing the gcode IF the XY hasn't moved, Z is usually locked enough to not move

another way would be to reslice to cut the printed part, and glue the rest