#Help! No printer attached on touch mode, but works on Marlin

1 messages · Page 1 of 1 (latest)

native epoch
#

Hi there! I have a Creality CR-10 im trying to tinker with. It currently has an SKR V1.4 Turbo board from BigTreeTech, and a TFT35_V3.0.26. The printer works with Marlin, able to heat up, move, extrude etc etc, but when I enter touch mode, it says there is no printer attached. What may be causing this issue?

IMG_5279.jpg
rose thicketBOT
#
AI Help

It sounds like the touch mode issue on your Creality CR-10 with the SKR V1.4 Turbo board and TFT35 display may be due to a communication error between the motherboard and the touchscreen. Here are a few troubleshooting steps you can try:

  1. Ensure that all the cables connecting the SKR V1.4 Turbo board to the TFT35 display are securely plugged in and not loose.
  2. Check the firmware settings on both the motherboard and display to ensure they are compatible and correctly configured for communication.
  3. Update the firmware on both the SKR V1.4 Turbo board and TFT35 display to the latest versions, in case there are any bugs or inconsistencies in the current firmware.
  4. If the issue persists, consider reaching out to the manufacturer or online forums for specific troubleshooting steps related to the SKR V1.4 Turbo board and TFT35 display.

If your issue is not resolved, you may need to seek further assistance from Creality, BigTreeTech, or the online community for more advanced troub...

WARNING: This response is AI generated and may contain errors.