Need help writing custom purge G-Code

[obsidian minnow]

As the title says. I am running an ender 3 v3 ke with klipper. I want the gcode to send the bed to 0, the nozzle to 0, then bring it down to z=4 then pruge to whatever orca slicer says.

[cedar spoke]

AI Help

To set up G-code for your Ender 3 V2 with Klipper firmware to move the bed and nozzle as described, you can use the following commands:

1. Send the bed to 0: G0 X0 Y0
2. Send the nozzle to 0: G0 Z0
3. Move the nozzle to Z=4: G0 Z4

It's essential to calibrate and verify these moves to ensure they are within the safe operating limits of your 3D printer. For purging as per the slicer settings, you can use additional commands based on the specific requirements given by your slicer.

Feel free to adjust the positions and speeds in the G-code to meet your exact needs. Make sure to test these commands carefully to protect your printer from any accidental damage.

WARNING: This response is AI generated and may contain errors.

[haughty stone]

i mean you need anything more?

G1 E(puge distance)```