#Weird Thing

1 messages · Page 1 of 1 (latest)

obsidian ingot
#

It keeps doing these parts where it's missing or not staying? Idk happens on both supports and non supports. I have a bambu P1S. Using Elegoo pla rapid plus.

20250518_192900.jpg 20250518_194859.jpg
upper mulchBOT
#
AI Help

It sounds like you may be experiencing issues with adhesion or layer adhesion. Here are a few things you can try to troubleshoot this issue:

  1. Check your print bed level to ensure it is properly adjusted.
  2. Clean the print bed surface with isopropyl alcohol to remove any oils or residue.
  3. Increase the bed and nozzle temperatures slightly to improve adhesion.
  4. Slow down the print speed to allow each layer to properly adhere.
  5. Consider using a brim or raft for better adhesion.

If the issue persists, please provide more specific details or consider reaching out to the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
upper mulchBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

winter sierra
obsidian ingot