out of range

[river robin]

Printer: ender 3 pro
Board: SKR mini e3 v3
im getting a move out of range issue when i try to print something
Move out of range: 315.000 215.000 10.000 [-5.000]

[hollow pendant]

AI Help

The "Move out of range" error typically occurs when the print head attempts to move beyond the physical boundaries of the printer. This can often be caused by incorrect firmware settings or misalignment of the printer's axes.

To troubleshoot this issue with your Ender 3 Pro and SKR Mini E3 v3:

1. Check your printer's firmware settings to ensure that the print volume parameters match the physical dimensions of your printer.
2. Verify that there are no physical obstructions limiting the movement of the print head in any direction.
3. Make sure your printer's axes are properly calibrated and the endstops are correctly positioned.
4. Double-check all wiring connections to ensure they are secure and functioning properly.

If the issue persists, you may need to further investigate your firmware settings and possibly reflash the firmware with the correct parameters for your printer.

WARNING: This response is AI generated and may contain errors.

[echo badge]

are you using klipper?

[river robin]

yes

[echo badge]

from your first picture you are getting negative Y value as far as i know

and you cant move into negative

is that happening during HOMING or during what proces

[river robin]

tbh i cant remember atm why i put that picture there, maybe omit that one for now

the second one im more concerned since its when im about to print after it gets up to temp, the 315 is x correct? that should not be a valid coordinate

[echo badge]

yes first one is X then Y then Z

X Y Z

[river robin]

how can i send my config so u can look at it

x max is 235