#Pico MMU Servo Toubles

1 messages · Page 1 of 1 (latest)

mild harness
#

I am running the Pico MMU and over time the 0 position will horribly mess up, try and spin it in the wrong direction. I am runing this on my Ender 3 V3 KE. Any help would be appreciated!

lofty ridgeBOT
#
AI Help

It sounds like you may be experiencing a calibration issue with your Pico MMU and Ender 3 V3 KE. I would recommend rechecking the setup and calibration of the MMU system, ensuring all connections are secure, and recalibrating the system according to the manufacturer's guidelines. It may also be helpful to check for any firmware updates that could potentially address this issue. If the problem persists, reaching out to the manufacturer or a community forum for additional guidance may be beneficial.

WARNING: This response is AI generated and may contain errors.