Leveling the bed | 3D Printing | Page 1

pale prism May 8, 2025, 2:23 PM

#

Hey so i m having a problem i turn on my geeetech prusa i3 pro b and i auto home, then i procced to level the bed with a paper all seems fine. Turn on and auto home and now there is no paper than can go under the nozzle way to tight ... Its like some how it loses the level... Maybe the z endstop?

limber heraldBOT May 8, 2025, 2:23 PM

#

pale prism Hey so i m having a problem i turn on my geeetech prusa i3 pro b and i auto home...

#

AI Help

It sounds like your Z endstop might need adjusting or replacing. Try checking the position of the Z endstop switch to ensure it is triggering properly when the nozzle reaches the bed during auto-homing. If it seems fine, you might need to recalibrate your Z-axis or check for any loose connections. If the issue persists, it could be a more complex problem with your printer's firmware or hardware that may require further troubleshooting.

pale prism May 8, 2025, 3:23 PM

#

Exchanged y endstop and z endstop and happens the same... I have a glass so even if the bed was warped it would be ok...

pale prism May 8, 2025, 3:59 PM

#

I think something like this would help but i dont undestand very well whats he doing.
https://youtu.be/o_qrpnocmaM?si=hFK_zQUrGCjwHNV8

YouTube

ron mason

3d printer bed leveling issue, easy fix,auto home issue, easy fix.

3d printer bed leveling issue, easy fix,auto home issue, easy fix.This is for a bluemaker, but should apply to any that has the same switches.

▶ Play video

pale prism May 8, 2025, 5:24 PM

#

Bump

limber heraldBOT May 8, 2025, 7:27 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

pale prism May 9, 2025, 3:18 AM

#

Bump

#Leveling the bed