Help me fix it | 3D Printing | Page 1

shell tinsel May 4, 2025, 1:23 AM

#

Idk the how to fix it it was working fine I think it's the firmware

cobalt deltaBOT May 4, 2025, 1:23 AM

#

shell tinsel Idk the how to fix it it was working fine I think it's the firmware

#

AI Help

It is possible that updating or re-installing the firmware on your 3D printer could help resolve the issue. You can usually find instructions on how to update firmware in the user manual or on the manufacturer's website. Remember to follow the steps carefully to avoid any potential issues.

shell tinsel May 4, 2025, 1:23 AM

#

I also don't know what firmware I needed

pallid agate May 4, 2025, 3:09 PM

#

is there anything physically jamming the motors

#

did you hear the motors moving at all

#

or straining

cobalt deltaBOT May 4, 2025, 5:12 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

cold zephyr May 6, 2025, 3:43 AM

#

ik this sounds dumb.. but did you make sure the motors are plugged in and theres nothing physically stopping the printer axises from moving

#Help me fix it