#“Homing failed printer halted please reset” after installing new update on Ender 3 Pro with BL touch

1 messages · Page 1 of 1 (latest)

spice helm
#

So, my Ender 3 Pro has a BL touch on it and it seems every few week it needs a new firmware update. I just did another firmware update. I turned it on, went to level the bed and it said "Homing failed printer halted please reset." Does anyone know why this is? I need that newer firmware to continue printing (since the BL touch just blinks red without it).

This was after finding the firmware that specifically said it was for the BL touch. I have no clue what is going on.

Can someone help me?

viscid dragonBOT
#
AI Help

It sounds like the homing error you're experiencing may be related to the BL touch settings or firmware update process. Here are a few troubleshooting steps you can try:

  1. Double-check all connections: Make sure all cables and connections between the BL touch and your printer board are secure and properly connected.

  2. Verify firmware settings: Ensure that the firmware settings for the BL touch are correctly configured. Make sure the correct probe offsets and other parameters are set in the firmware.

  3. Reset printer: Try powering off the printer, waiting for a few minutes, and then turning it back on to see if the issue resolves itself.

  4. Check for firmware compatibility: Ensure that the firmware version you installed is fully compatible with your printer model and the BL touch. Sometimes firmware updates can cause compatibility issues, so you may need to try a different version of the firmware.

If you've tried these steps and are still experiencing issues, you may want to s...

WARNING: This response is AI generated and may contain errors.
viscid dragonBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

earnest iris
#

I've never seen a printer "force" a firmware update. Revert to the previous know working firmware

worthy python
#

check and ensure all of your cables are properly plugged in. You shouldnt have to reflash firmware for it to work.