Help pls | 3D Printing | Page 1

steel lintel Apr 25, 2025, 2:23 PM

#

I'm using a Sovol SV06 printer and was having sticking issues, but after leveling the bed and adjusting the Z offset, it seems better. Now, The first layer seems fine, but once it gets to the second or third layer, it starts failing. It also leaves strange gaps in the first layer. I’ve attached a picture of it. Can someone please tell me if this is a problem and how to fix it?"

real vineBOT Apr 25, 2025, 2:23 PM

#

steel lintel I'm using a Sovol SV06 printer and was having sticking issues, but after levelin...

#

AI Help

It sounds like you may be experiencing issues with your print bed adhesion or nozzle clogging. The gaps in the first layer could indicate that the nozzle is too far from the bed. Try adjusting your Z offset slightly closer to the bed to improve adhesion. As for the issue with the second and third layers failing, it could be due to an inconsistent extrusion rate or a partially clogged nozzle. Make sure your filament is flowing smoothly and clean your nozzle if necessary. Additionally, check your print settings to ensure they are appropriate for the filament you are using. If the issue persists, feel free to provide more details for further assistance.

gloomy nebula Apr 25, 2025, 2:53 PM

#

steel lintel I'm using a Sovol SV06 printer and was having sticking issues, but after levelin...

lower the z offset some more, should be mashing it into the bed, not setting it ontop

real vineBOT Apr 25, 2025, 2:53 PM

#

Leveling Your Printer
Here is a handy infographic that will help with levelling your printer.

#Help pls