#Bambu A1 nozzle temp malfunction

1 messages · Page 1 of 1 (latest)

past pewter
#

Hello, i replaced my nozzle on my A1 a while ago and haven't really used the printer sense but i got a project i wanna do so iv bin using it again but i keep getting
Nozzle temp malfunction
and thats it Only happens on longer prints
but if i print a bench on fast speeds it dose not happen
i googled a bit and saw to check some things and nothing looks broken or disconnected the temp when heating up dose not Jump like the sensor is broken Im just really confused on why this is happening now.

willow depotBOT
#
AI Help

It sounds like you may be experiencing thermal issues during longer prints on your A1 printer. Some potential causes and solutions you can try are:

  1. Check the wiring: Ensure that the wiring from the thermistor to the control board is securely connected and not damaged. A loose or damaged connection could cause temperature fluctuations.

  2. Insulation: Check that the heating block, nozzle, and thermistor are properly insulated. Insulation can help maintain a stable temperature during longer prints.

  3. Cooling: Make sure that the fan cooling the hotend is functioning properly. Inadequate cooling can lead to heat creep, affecting temperature stability.

  4. PID tuning: Consider re-calibrating the PID settings for the hotend. This can help optimize temperature control during longer prints.

  5. Firmware update: Check if there are any firmware updates available for your printer that may address temperature control issues.

If you've checked these potential causes and the issue persists...

WARNING: This response is AI generated and may contain errors.
tropic atlas
#

Did you run hotend PID calibration?

#

Oh nvm I confused it with thermistor vaulthah me moment

past pewter
#

i was like tf is that LMAO