Help with vase mode | 3D Printing | Page 1

muted widget Apr 15, 2025, 10:46 PM

#

While in vase mode, for some reason it only prints the first few layers of this bridge and then stops. How can I model this so it fully prints the bridge?

rose obsidianBOT Apr 15, 2025, 10:46 PM

#

muted widget While in vase mode, for some reason it only prints the first few layers of this ...

#

AI Help

To ensure that the entire bridge prints in vase mode, you may need to adjust the model's thickness or increase the number of perimeter walls. Additionally, check your slicer settings to make sure the layer height is appropriate for the model and that there are no issues with the filament feed or extruder. If the issue persists, you may want to try printing the bridge in a different orientation or using a different slicing software.

muted widget Apr 15, 2025, 10:55 PM

#

I notice that there its 2 walls thick here for reason but then stops, so could that be the reason?

#Help with vase mode