#Ender 3 v3 se

1 messages · Page 1 of 1 (latest)

warm spoke
#

So I just got this printer and I did the model print on the sd card, it was a scraper but called a shovel. Printed ok, now I’m trying to print a custom print and I’m having issues. First layer goes down good, second layer good, when it starts the outline for the wall it seems to jump up way to high and the filliment doesn’t stick. I’ll film a video and see if I can show what I’m talking about.

dusty micaBOT
#
AI Help

It sounds like you may be experiencing some issues with bed leveling or possibly your Z-axis calibration. I recommend checking your bed leveling to ensure it is properly calibrated and checking the Z-axis height to make sure it is set correctly. It's also a good idea to check your slicer settings to ensure they are optimized for your specific printer and filament. Feel free to share the video if you need more specific guidance.

WARNING: This response is AI generated and may contain errors.