#Weird noise when heating up (Ender 3 V3 KE)

1 messages · Page 1 of 1 (latest)

charred ingot
#

I heard this noise once before but it was gone after a cleaning. Noe this noise is back again, I don't know what causes it.

red prairieBOT
#
AI Help

It sounds like you may be experiencing some issue with your 3D printer's mechanics. I recommend checking the belts, rods, and bearings for any signs of wear or damage. Additionally, make sure your printer's bed is properly leveled and clean. If the issue persists, it may be helpful to contact the manufacturer or seek assistance from a professional technician.

WARNING: This response is AI generated and may contain errors.
ember garnet
#

It tries to spin up and eventually gets there, until it doesn't and you get a super clog

red prairieBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.