#Nebula pad system error

1 messages · Page 1 of 1 (latest)

proud verge
#

I recently installed the nebula kit on my e3V3SE, it worked fine but when I turned the printer off and at a later time on again it says “system error, try restarting” restarting doesn’t fix it. I already reset the nebula and then it worked again but when turning it on and off it gives the error again…

IMG_8775.jpg
hazy garnetBOT
#
AI Help

It sounds like there may be an issue with the communication between the nebula kit and the printer when the power is cycled. Have you checked for any loose connections or updated the firmware for both the printer and the nebula kit? It's also a good idea to reach out to the manufacturer of the nebula kit for further troubleshooting steps.

WARNING: This response is AI generated and may contain errors.
proud verge
#

I tried restarting and reset but didn’t work

hazy garnetBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

proud verge
#

Open

smoky root
#

Try reflashing/reinstalling it. Seems like a common error with not a good solution

hazy garnetBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

proud verge
hazy garnetBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

proud verge
#

When I factory reset the firmware is still on there

smoky root
#

I have no clue tbh, these ready-to-use klipper implementations are weird in my opinion

hazy garnetBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

proud verge