Corners messsing up on part

[brisk relic]

The upright picture is what its supposed to look like and ive printed this piece fine before. But now all of a sudden the corners are messing up. Anyone know what the issue is? Printing on a bambu a1 with ams

[coral shuttle]

AI Help

It looks like the issue may be related to the sudden warping of corners on your print. This could be caused by a variety of factors, such as changes in environmental conditions (e.g. temperature, humidity), bed leveling issues, improper filament feed, or even a clogged nozzle.

Here are a few troubleshooting steps you can try:

1. Check the bed leveling to ensure it is properly calibrated.
2. Verify that the filament is feeding smoothly and consistently.
3. Clean the print bed to remove any debris or residue that may be affecting adhesion.
4. Inspect the nozzle for any signs of clogging or wear.

If the issue persists, I recommend reaching out to the manufacturer of your printer for further assistance.

WARNING: This response is AI generated and may contain errors.

[stiff crag]

try washing your bed with dawn dish soap (or any safe dish soap) warm water and a palstic scrub brush. finger oils get on the bed and keep things from adhering. looks like corners are lifting causing that mess.

[brisk relic]

I havnt noticed the part lifting off the plate at all if thats what you mean. But ill try it anyway I could be wrong

I have been using a lot of hairspray on it recently 😳

[brisk relic]

Washed the bed and im still having the same issues

[queen field]

Cooling, slow down your outer wall speed