#Changed out my Heater Cartridge and ran a PID Autotune and now my printer does this

1 messages · Page 1 of 1 (latest)

winter tangle
#

It was "fine" before I changed it, the old ones wires were exposed and shorted out recently so I swapped it and now it is doing this.

Any idea how to fix this? I have installed it properly.

image.png
wintry shuttleBOT
#
AI Help

It sounds like you may be dealing with a wiring issue in your 3D printer. I would recommend double-checking all connections and ensuring that everything is properly insulated and secured. If the problem persists, I would suggest reaching out to the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
winter tangle
#

Kingroon KP3s Pro Matte White Filament, Phaesus dragonfly 6v hotend

limber kelp
#

Pronterface in the big 25?

winter tangle
limber kelp
#

But it seems to be doing exactly as expected

limber kelp
winter tangle
#

Ok so I shouldn't stress about it

#

Nor should I be concerned with the temperature fluctuating 2-3c above and below the 200c mark

limber kelp
#

Fluctuating 2-3 is fine

#

You can pid tune with more cycles if you wish

winter tangle
#

And it will even it out?

limber kelp
#

Maybe

winter tangle
#

Ight. I'll try that out

winter tangle
wintry shuttleBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

wide fulcrum
#

I found PID autotune absolutely sucks for overvolted cartridges, at least mine

#

You could try passing M302 S190 or 5 below your min print temp

#

on marlin at least

wintry shuttleBOT
wide fulcrum
#

@winter tangle ping just in case

winter tangle