#Ender 3V2 Belts

1 messages · Page 1 of 1 (latest)

broken tide
#

Hi! I'm hoping to get some help/resources. I had someone in a reddit community mention that the belts on 3D printers I have at work are loose (specifically the belts that move the print head) and I did some research and according to the videos I have seen and the ways they have said to test it, they are very loose.

I brought this up to my boss and co-worker. My co-worker says there is no way to tighten the belts (according to an intern we have). But I highly doubt someone on reddit would tell me to tighten them if its not possible.

My co-worker says they can't be tighten do to how the belts are installed (I'm including a pic to show the belt set up). The belts come down into this clip, and due to that she says you can't tighten them. I just really want this to work the way they need too.

0327251530a_HDR.jpg 0327251516.jpg
stark dewBOT
#
AI Help

It is indeed possible to tighten the belts on most 3D printers. The method can vary depending on the specific printer model, but typically involves adjusting the tension of the belts using tensioners or by manually adjusting the belt attachment points.

I recommend referring to the user manual or online guides specific to your 3D printer model for detailed instructions on how to properly tighten the belts. If your co-worker is unsure about this process, perhaps reaching out to the manufacturer's customer support or online forums for assistance would be beneficial.

As for the picture you mentioned, unfortunately, I cannot view images in this text-based communication. However, if you provide more specific details about the 3D printer model or describe the belt setup in further detail, I may be able to offer additional guidance.

WARNING: This response is AI generated and may contain errors.
smoky meteor
#

if you don't get good results with those you can print better replacements (i've replaced X)

#

@broken tide

image.png image.png
broken tide