Cr10s pro v2 issues | 3D Printing | Page 1

prisma narwhal Mar 25, 2025, 9:07 PM

#

So recently put a microswiss direct drive with 0.4mm on my cr10s pro v2, sorted the flow rate and added ironing for the top layer, coasting and z hop and I get the top results of the first 2, the initial layers go down nearly perfect. I do the same test on my ender3 v2with direct drive and it's nearly perfect on top.
Bed on each printer was leveled before each print

daring boltBOT Mar 25, 2025, 9:07 PM

#

prisma narwhal So recently put a microswiss direct drive with 0.4mm on my cr10s pro v2, sorted ...

#

Could you include more info?

To help you get the best help try to include as much information as you can such as:
• Printer make and model,
• Any Mods,
• Firmware,
• Filament material and temps,
• Slicer,
• Any recent changes,
• What have you tried so far.

Images can really help with debugging a printer! Consider adding some to your post of the print and the printer.

copper hamlet Mar 25, 2025, 9:08 PM

#

ok what's the issue

prisma narwhal Mar 25, 2025, 9:09 PM

#

How to get the top layer to look better

copper hamlet Mar 25, 2025, 9:10 PM

#

do the walls seperate like that in the middle layers? def underextruding

prisma narwhal Mar 25, 2025, 9:12 PM

#

It is set to 20% infill, I turned the flow from 100 to 80 and did a XYZ cube and came out nearly perfect

#

From that

#

#

To that

#

#Cr10s pro v2 issues