#TMC2209 Current

1 messages · Page 1 of 1 (latest)

wary frost
#

Hello. I have a Creality CR-10 SE and have installed some higher current motors. When I set the run_current to anything Higher than 1.33, it will revert back to 1.33 amps. I though TMC2209's were rated for 2A continuous. Any help would be appreciated. Thanks!

pure ridgeBOT
#
AI Help

Hello! It sounds like you may be experiencing a limitation with the TMC2209 stepper motor drivers on your Creality CR-10 SE. Some firmware versions or configurations may have restrictions on the current setting for safety or compatibility reasons.

To address this issue, you could try updating your firmware to the latest version or checking the configuration settings to see if there are any specific limits set for the current. You may also want to reach out to the manufacturer or forums for advice on how to adjust the current settings properly.

I hope this helps, and good luck with your motor upgrade! Let me know if you need more assistance.

WARNING: This response is AI generated and may contain errors.