Ender 3v2 with Klipper issues

[molten quiver]

Have had this printer awhile now with little issues printing. Recently installed Klipper for it and I swear I’ve done everything I should’ve but it is printing horribly and I don’t know why.

I’ve attached an example print, this filament is brand new, I’m nearly certain the issue is with Klipper or the slicer.

[long flax]

AI Help

It sounds like the issue may be related to the settings in Klipper or the slicer. I would recommend checking the following:

1. Make sure your printer configuration in Klipper is correctly set up for your specific printer model.
2. Check and adjust the temperature settings in your slicer for the new filament you are using.
3. Verify that the filament diameter and extrusion multiplier settings are correct in your slicer.
4. Check the print speed settings in the slicer to ensure they are appropriate for your printer and filament.

If the issue persists, it may be helpful to reach out to the Klipper community or the support channels for your specific printer model for further assistance.

WARNING: This response is AI generated and may contain errors.

[gentle flax]

What is "everything I should"?

[long flax]

Calibration
Calibration and tuning can help with all aspects of print quality.
Extruder calibration should be done only once, and then again if you change any hardware on your extruder setup (new tube, gear drive, different motor, etc).
Flow calculation should be done for every filament, even different colours from the same brand.

A number of calibration and tuning guides exist online:

• Teaching Tech
• Michael Hackney Extruder Calibration
• Toms Extruder Calibration
• Toms Calibration Guide
• Matts Hub Extruder Calibration
• Tolerance Calibration
• Andrew Ellis' Print Tuning Guide

?calibration requested by: m.von.d#0

[gentle flax]

Any of these?

[molten quiver]

I didn’t do flow calibration for my new filament, but I’ve done everything else on that list

[molten quiver]

Install Klipper, configure it for Ender 3v2, the stuff on the list, bed leveling, lowered my printing speed and accel

[gentle flax]

Dry your filament and tune flow

Yes, new filament can be wet

[plain trail]

what slicer are you using

[molten quiver]

Orca, never used it before was told its supposed to be better than cura

[molten quiver]

Is tuning flow different from pressure advance, or the same?

[long flax]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[tepid fractal]

Yes they are different...

Pressure advance is flow for ONLY the edges and corners.

Flow is for the rest of the print bits.

[molten quiver]

How do i configure flow with klipper? From looking it up i didnt find anything, just the pressure advance. Or is it in the slicer?

[gentle flax]

https://ellis3dp.com/Print-Tuning-Guide/articles/extrusion_multiplier.html

[long flax]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.