#Help first layer calibration anycubic kobra 2 pro

1 messages · Page 1 of 1 (latest)

gentle sky
#

Anyone knows how i can get rid of the gap between the wall and the infill? And the issue mainly on the left side (addjusting z offset didnt help so far)

20250314_173425.jpg
chilly breachBOT
#
AI Help

It sounds like you may be dealing with an issue related to extrusion settings or possibly an inconsistent flow rate. Here are a few possible solutions to try:

  1. Check and calibrate your extruder steps/mm to ensure the correct amount of filament is being extruded.
  2. Verify that your filament diameter is accurately set in your slicer software.
  3. Adjust your extrusion multiplier in the slicer settings to increase or decrease the amount of filament being extruded.
  4. Increase the infill overlap percentage to help fill in the gaps between the infill and walls.
  5. Ensure that your printer's belts are properly tensioned to prevent any backlash or shifting during printing.

If adjusting the z offset did not resolve the issue, it is likely related to extrusion settings or slicer configurations. Experiment with these suggestions to see if any of them help improve the gap between the wall and infill.

WARNING: This response is AI generated and may contain errors.
chilly breachBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

shell comet
#

I’m a noob but maybe try increasing number of outside walls

next saddle