print failure from vibration or something else? | 3D Printing | Page 1

indigo spade Mar 13, 2025, 3:36 PM

#

Ender 3 V3 SE using orca slicer

valid riverBOT Mar 13, 2025, 3:36 PM

#

indigo spade Ender 3 V3 SE using orca slicer

#

AI Help

What specific question do you have about using Orca Slicer with your Ender 3 V3 SE? I can help with troubleshooting or provide guidance on settings if needed.

indigo spade Mar 13, 2025, 3:52 PM

#

something ive noticed during the 3rd attempt (printing right now) is that this section is immediately after a bridge/overhang

#

could it be under-extrusion as it transitions from low flow back to high flow? I have a direct drive extruder on my print head

covert mason Mar 13, 2025, 4:07 PM

#

check the overlays in the slicer speed n flow n stuff

indigo spade Mar 13, 2025, 4:57 PM

#

#

#

@covert mason

#

I got a print that didn't detach from the build plate by brute-forcing it with a ton of supports. The outside perimeter still has these ripples but the part is functional. Gonna close this

#print failure from vibration or something else?