Problem with ender 3 pro SKR mini e3 v3 with skipper.

[elfin phoenix]

The fillament is not attatching, the part cooling fan is not turned on uinless i manually do so, when i ajusted the z offset to be 0.01 mm lower it now goes up by like 3cm into the air when printing the safety line, doesnt extrude and just stops at the top right courner. Im not getting any error message either. ivew been having all these problems ever since i got the skr mini e3 v3

[cosmic cedar]

AI Help

It sounds like you may be experiencing several issues with your 3D printer setup. Here are some recommendations to address each problem:

1. Filament not attaching: Ensure that your hotend and bed are at the correct temperatures for the filament you are using. Also, make sure the hotend is properly calibrated and not clogged.

2. Part cooling fan not turning on: This could be a configuration issue with the SKR Mini E3 v3. Check your slicer settings and ensure that the fan is set to turn on at the correct layers.

3. Z-offset causing the nozzle to move up too high: Re-adjust your Z-offset to a more appropriate value. Make sure to re-level your bed after changing the offset.

4. Extrusion stopping and nozzle moving to the top right corner: This could be a firmware or configuration issue. Check your G-code settings and make sure they are correct for your printer model.

If you continue to experience issues, consider reaching out to the 3D printer manufacturer or online ...

WARNING: This response is AI generated and may contain errors.

[elfin phoenix]

this is my config file

[elfin phoenix]

It is leveled.(immage for fan on slicer), dont know what to do for the z offset.

[glacial hare]

Hmm

What slicer is that

[elfin phoenix]

Cura

also my top right bed screw is like allways suspended

Im wondering if i need to lower my z end

[glacial hare]

Yes

Your springs should be about half compressed

[elfin phoenix]

Thats what i thought lol

Heres a vid btw

[glacial hare]

Your bed is definetly dirty

[elfin phoenix]

Oh so i should clean it?

[glacial hare]

Wash it with soap and water

[elfin phoenix]

Yes sir

[glacial hare]

And you can tick z offset a little lower

[elfin phoenix]

Also aproximatedly how big of a gap between the metal where the screws go and the heatplate?

[glacial hare]

Do you mean the y carriage?

Uhhhh maybe .75 inches

[elfin phoenix]

In cm?

[glacial hare]

Half an inch?

Uhhh 2cm

1.5

[elfin phoenix]

oh ok

And what should i use to clean the plate? (cloth, sponge?)

[glacial hare]

The springs probably can't go less than 1cm

[glacial hare]

Wash it like a plate haha

[elfin phoenix]

ah ok

[glacial hare]

Soap water scrub

[elfin phoenix]

brb then

[glacial hare]

Then dry it, and wipe with isopropyl alcohol

[elfin phoenix]

ye, hotta let the plate cool down first

[elfin phoenix]

Cleaned, now its time for the alcohol

but i cant find my rag .-.

[glacial hare]

Haha

[elfin phoenix]

I found it

Now im going to lower the bed and then attatch the glass bed

Huh its at like 1.3cm

[elfin phoenix]

allright its cleaned and attatched, im going to level it and then see how it goes

aparently i have 3 printer.cfg?

[elfin phoenix]

Leveli ng took forever

[elfin phoenix]

My printer is running smoth as ever!