#k1 layer issue

1 messages · Page 1 of 1 (latest)

vestal condor
#

Hello. I'm getting a bad first layer, and the other layers are not good either. I tried different filaments and replaced the unicorn nozzle with a new one, but it didn’t work. Should I recalibrate my bed level? Any advice?

IMG_9826.jpeg screenshoot.png
wild sableBOT
#
AI Help

It's excellent that you've already tried different filaments and a new nozzle. Yes, recalibrating your bed level may help improve your print quality. Make sure your bed is clean and double-check your nozzle height. Additionally, ensure your print settings are correct for the filament you're using. If the issue persists, adjusting your print temperature or checking for a clogged nozzle could be beneficial.

WARNING: This response is AI generated and may contain errors.