#Ender 3 Extrusion problems

1 messages · Page 1 of 1 (latest)

golden spoke
#

My ender 3 is having what seems to be extrusion problems. The example in the image was pretty bad, but usually it’s a bit more subtle. Sometimes the problem just goes away for a while before coming back. I had just done a cold pull right before this as well.

IMG_3534.jpg
woeful raftBOT
#
AI Help

It looks like you may be experiencing inconsistent extrusion which could be caused by several factors such as a clogged nozzle, incorrect filament diameter settings, or a partial clog in the hotend. I recommend checking and cleaning your nozzle, ensuring the filament diameter in your slicer settings matches your filament, and checking for any jams in the hotend. It's also possible that your extruder gear may need cleaning or adjusting. Make sure your PTFE tube is seated correctly as well. If the issue persists, feel free to reach out for further assistance.

WARNING: This response is AI generated and may contain errors.
woeful raftBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

dull geyser
#

I’m nowhere close to an expert but this happened to my e3v2 when the nozzle was too close to the bed