Slow gyroid infill speeds with orca | 3D Printing | Page 1

coarse birch Feb 15, 2025, 4:30 PM

#

Trying to setup orca for my sovol sv03 and the gyroid goes pretty slow. Any tips on settings to make it better?

kind pewterBOT Feb 15, 2025, 4:30 PM

#

coarse birch Trying to setup orca for my sovol sv03 and the gyroid goes pretty slow. Any tips...

#

AI Help

To improve the speed of the gyroid infill pattern on your Sovol SV03 using OctoPrint, you can adjust the print speed settings in your slicer software. Try increasing the infill speed and travel speed to see if it improves the print speed while maintaining print quality. Additionally, check the printer's acceleration and jerk settings to make sure they are optimized for faster printing. Experiment with these settings while keeping an eye on print quality to find the right balance for your needs.

coarse birch Feb 15, 2025, 4:31 PM

#

#

with Prusa it was fine and pretty fast actually. normal speeds for external walls

coarse birch Feb 15, 2025, 5:27 PM

#

normal speeds with straight infills

dusky saffron Feb 15, 2025, 5:30 PM

#

coarse birch with Prusa it was fine and pretty fast actually. normal speeds for external wall...

whats the speeds and accels in prusa then?if it worked at those speeds copy it over to orca

coarse birch Feb 15, 2025, 5:32 PM

#

I have, that's what is weirding me out

dusky saffron Feb 15, 2025, 5:34 PM

#

from the video its still on the slower layers if that helps

#Slow gyroid infill speeds with orca