#Klipper on v3 KE

1 messages · Page 1 of 1 (latest)

open cliff
#

I'm pretty new to printing and just updated my Ender3 V3 KE to "real" Klipper. I am using Guilouz Creality helper script.
I have never used Klipper before so I am not sure what I need to install.
I don't have a camera atm so that's easy but what about Improvements and Remote access. Any of those that I "need to have"?
Also, are there any calibration or settings that i need to (re)do after upgrading?

halcyon inletBOT
#
AI Help

Congratulations on updating your Ender3 to Klipper! The Guilouz Creality helper script should guide you through most of the necessary installations. As for improvements and remote access, they are not necessary components, but they can enhance your printing experience. Improvements can include features like linear advance, pressure advance, or input shaping, which can improve print quality. Remote access, such as OctoPrint or AstroPrint, allows you to monitor and control your printer from a distance.

After upgrading to Klipper, it's recommended to recalibrate your printer to ensure optimal performance. You may need to recalibrate steps/mm, PID tuning, and re-level your bed. It's also a good idea to check and adjust your slicer settings to match the new firmware.

Overall, take your time to familiarize yourself with Klipper and its settings. Don't hesitate to reach out to community forums or resources for any specific questions or issues you may encounter during the transition. Enjo...

WARNING: This response is AI generated and may contain errors.
halcyon inletBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

strong crag