ender 13 deform prints(image hard to see)

[weak mauve]

trying to print a dummy 13 with pegt but every time i try to print the joint they don't fit and end up slipping off the bed sometimes. i just dehumidify the filament wondering if the will fix it but any tips for this fix?

[polar spoke]

AI Help

It sounds like you may be facing issues with bed adhesion or printing settings rather than filament moisture. Here are tips to improve the joint fitting issue:

1. Ensure your printer bed is level and properly calibrated.
2. Increase the bed temperature for better adhesion.
3. Adjust the first layer height to ensure proper adhesion.
4. Increase the infill density for better structural integrity.
5. Check the model for errors or inconsistencies that may affect the joint fit.
6. Consider using a brim or rafts for better stability during printing.

If these tips don't solve the issue, please provide more details about your printer and settings for further assistance.

WARNING: This response is AI generated and may contain errors.

[polar spoke]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[west beacon]

• Drying it will help
• cooling fan on at around %
• half speed \ slow first layer
• add brim or clean bed for adhesion.

Photo is super fuzzy, but is the joint round?

[weak mauve]

sorry late, yes its a round joint

[west beacon]

I worded that badly too.
Did it print round?
Or more of an oval shape?

[weak mauve]

its suppose to be round but it comes out oval shape

[west beacon]

Ah ok.

• tune and tighen you belts.
• see if your slicer allows you to tune x\y compensation \ horizontal expansion.

[weak mauve]

ok thx have a good day