#need help with elegoo Neptune 2

1 messages · Page 1 of 1 (latest)

round cradle
#

Hi I'm very new to 3d printing and just set this up for printer up. My first print came loose from the bed so I checked into it and was told to check the leveling. I've gotten all 4 corners for the most part level to where the paper just barely drags on it. But the center catches the paper and bunches it up and won't let it move. Am I doing something wrong?

Trying to level the bed and have no idea what I'm doing.

neat tideBOT
#
AI Help

It sounds like you may need to adjust the bed leveling of your 3D printer. If the center catches the paper and bunches it up, it means that area is too close to the nozzle. Try adjusting the bed level again, paying extra attention to the center. You may need to slightly raise that part of the bed so the paper can slide smoothly. Keep adjusting until the paper can move freely under the nozzle without catching or bunching up. Good luck with your prints!

WARNING: This response is AI generated and may contain errors.
round cradle
#

I have tried leveling many times and I get the same results each time.

neat tideBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

neat tideBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

round cradle
#

Still not resolved