#I just put in new filament with the same diameter and its not getting pulled in

1 messages · Page 1 of 1 (latest)

keen coyote
#

Filament isnt being pulled in to print with no filament is coming out of the printer at the nozzle neither. Any Ideas

frail salmonBOT
#
AI Help

It sounds like you may have a clog in your extruder or a feeding issue. Here are a few possible solutions to try:

  1. Check that the filament is loaded correctly and is able to move freely through the extruder.
  2. Clean the nozzle and extruder gear to remove any debris that may be causing a blockage.
  3. Increase the printing temperature slightly to help unclog the nozzle.
  4. Check the tension on the filament spool to ensure it is feeding properly.
    If these solutions do not work, please refer to your printer's manual or contact the manufacturer for further assistance.
WARNING: This response is AI generated and may contain errors.
keen coyote
#

?solved