My Ender 3 V2 Neo doesn't want to auto home or level out the bed

[rancid wasp]

It's basically something to do with the probe i believe because it will flash red multiple times right before it gets in place to probe the bed. I'm not sure but I appreciate any help you guys could give. THX :D https://tenor.com/view/haechan-127hivemind-alpha-wolf-nct-nct-haechan-gif-26541424

[deep sky]

AI Help

It sounds like your auto bed leveling probe may be experiencing some issues. The flashing red light before probing could indicate a problem with the probe itself or its connection. I would recommend checking the probe for any visible damage or loose connections, and also verifying that the probe is correctly calibrated in your printer's firmware settings. If the issue persists, you may need to replace the probe. Let me know if you need further assistance!

WARNING: This response is AI generated and may contain errors.

[rancid wasp]

It is also worth noting that my printer nozzle started to push into the bed a little before I quickly turned it off

I was monitoring it because it was acting up and I wanted to see what was wrong

ALSO worth mentioning that I printed something a few minutes before the error

I've factory reset it and everyhthing and I'm still getting the same result, a flashing red probe

[low gust]

destrine, do you still have the article from last time?
whats the timing of the flash code?

[deep sky]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[rancid wasp]

It’s just rapidly flashing red again

I recentered and everything rn because everything was going good

But once I started to set the z offset, it all went back to what it was doing

[low gust]

It's working now?

Or

Still flashing....

I relooked at the link...
Flashing red can be caused by:

https://www.3dprintbeast.com/bltouch-blinking-red/

[deep sky]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[rancid wasp]

I’m seriously going to punch my 3d printer if nobody could help me😭

It’s annoying cause sometimes it wants to work and other times it doesn’t

I have no idea how I would even open up the probe holder and fix it

It’s so upsetting

[deep sky]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[rancid wasp]

dang

[grave thunder]

Its partially see thru right, use a torch to inspect if anything os obviously damaged or grimey
It probably dissassembles from the top
You can always buy a replacement probe they arent too expensive