#Print Quality is very Bad!

1 messages · Page 1 of 1 (latest)

misty swallow
#

Hello, I didn't change my temperature, cooling and flow settings, but still suddenly had this print result. I use PLA (Nozzle: 200 °C and Bed: 60 °C).

IMG_0125.jpg
errant hawkBOT
#
AI Help

It looks like your print is showing signs of under-extrusion, which can be caused by a number of factors. Here are some suggestions to troubleshoot the issue:

  1. Check for clogs in the nozzle and clean it if necessary.
  2. Make sure the filament is loaded correctly and feeding smoothly.
  3. Ensure that the filament diameter setting in your slicer matches the actual diameter of your filament.
  4. Check the tension of the extruder gear to ensure proper grip on the filament.
  5. Try increasing the printing temperature slightly to improve flow.

If these suggestions don't solve the issue, feel free to provide more details for further assistance.

WARNING: This response is AI generated and may contain errors.
hollow topaz
#

It looks like it could be a partial clog of your nozzle - if you have a nozzle needle I'd try to clear it that way, failing that I would do a cold pull

#

Also it could have clogged because 200c is a bit low - I would run at least 210

misty swallow
#

Thank you @hollow topaz ! I will try to clean the nozzle.