Question about outer wall line width | 3D Printing | Page 1

opaque lake Jan 31, 2025, 4:01 AM

#

I am using a layer height of .2mm, what is the best outer wall width to achieve smoother printers? I have it set ti .3 and I am getting smoother printer but dont want to ruin the structual integrity with thinner line. Shoud I go up to .45 or so?

oblique tigerBOT Jan 31, 2025, 4:01 AM

#

opaque lake I am using a layer height of .2mm, what is the best outer wall width to achieve ...

#

AI Help

For a layer height of 0.2mm, it is common to have the outer wall width set to be between 0.4mm to 0.6mm. A good starting point could be around 0.45mm, as you mentioned. This should help in achieving smoother prints without compromising structural integrity. You can experiment within this range to see what works best for your specific printer and the models you are printing.

opaque lake Jan 31, 2025, 4:03 AM

#

I am using Orca Slicer and here are my current settings

#Question about outer wall line width