Bed levelling issues | 3D Printing | Page 1

timid herald Jan 29, 2025, 2:00 PM

#

Hi I’ve been trying to level the bed an it seems only the left side is a bit high. The levelling knob for the left side has been brought to its lowest yet for the printer is too high any suggestions to help?

river skiffBOT Jan 29, 2025, 2:00 PM

#

timid herald Hi I’ve been trying to level the bed an it seems only the left side is a bit hig...

#

AI Help

It sounds like you may need to adjust the build plate itself. Check if there are any specific leveling screws or mechanisms on the left side that can be fine-tuned to bring that side down. If not, you may need to shim or adjust the build plate mounting to achieve proper leveling. Be sure to re-calibrate the printer after making any adjustments.

forest dagger Jan 29, 2025, 3:01 PM

#

timid herald Hi I’ve been trying to level the bed an it seems only the left side is a bit hig...

The printer prints too low on the left and too high on the right. What is the hanging plug on the left for?

timid herald Jan 29, 2025, 3:30 PM

#

There is no hanging plus for any sides

#

I set the Z offset to -1

forest dagger Jan 29, 2025, 3:34 PM

#

timid herald Hi I’ve been trying to level the bed an it seems only the left side is a bit hig...

#

And that is what then?

timid herald Jan 29, 2025, 4:16 PM

#

That was connected to the z limit switch

#

It was disconnected after installing the BL touch

#

I was told it was not necessary to have after installing the BL touch

#Bed levelling issues