AD5M - PETG - Fine Tuning

[fleet burrow]

Could someone help me finalize some settings. I’ve gotten as far as I can get I think with my limited knowledge. I’ve had the printer for 5 days (flash forge 5M) and after many test prints these are my latest and still showing minor issues.
Im printing new and dried hatchbox PETG at
235-245deg and between 20-40mm/s exterior depending on detail.
.19 layer height
I’m using flashprint 5 for my slicer

Most issues seem inconsistent in performance, machine based almost. Some areas are superb while others, that are equal in structure, display major flaws.

[quick heath]

AI Help

It sounds like you've made good progress with your FlashForge Finder and good job on narrowing down the settings for your PETG prints. Inconsistent print quality can be caused by various factors such as bed leveling, filament quality, slicer settings, or even mechanical issues with the printer.

Here are some steps you could take to troubleshoot the issues:

1. Calibrate your bed: Make sure your print bed is leveled correctly. An uneven bed can lead to inconsistent adhesion and layer height.

2. Check filament quality: Make sure your filament is of good quality and stored properly to avoid moisture absorption which can cause printing issues.

3. Temperature: Ensure that the temperature is consistent throughout the print. Fluctuations can lead to inconsistent extrusion.

4. Check for mechanical issues: Inspect your printer for any loose belts, pulleys, or any mechanical issues that could be causing the inconsistencies.

5. Calibrate extrusion: Make sure your extru...

WARNING: This response is AI generated and may contain errors.

[quick heath]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[fleet burrow]

Anyone?