Idk what to do | 3D Printing | Page 1

verbal basalt · 2025-01-20T00:26:10.621Z

So I started printing this voronoi laser cat from thingiverse it started on the this started to happen I tried using different filaments too and same thing happens I tried lowering heat all the way from 235,220, 210, 200 and same thing but when info different prints the filament sticks… any advice is great appreciated! .02mm 235/65 200 speed Kingroon KP3S Pro V2

AI Help

It sounds like you may be experiencing issues with the filament not sticking properly during the print. Here are a few troubleshooting steps you can try:

Check your bed leveling: Ensure that your print bed is properly leveled. Use a piece of paper to test the distance between the nozzle and the bed at different points.
Adjust print bed temperature: Try increasing the bed temperature slightly to improve adhesion. You can also try using a thin layer of glue stick or painter's tape on the print bed for better adhesion.
Clean the print bed: Make sure the print bed is clean and free of any dust or debris. You can use isopropyl alcohol to clean the bed before starting a new print.
Check your filament: Make sure that your filament is not tangled or causing any feeding issues. Check the filament spool for any knots or tangles that could be obstructing the filament flow.
Adjust printing speed: You mentioned a printing speed of 200. Try reducing the print speed to see if t...

#Idk what to do