First layer melted?

[flat lantern]

Can anyone tell me what is causing this? Looked around but can find any examples.

[left wind]

AI Help

I'd be happy to help! Could you please provide more information or a picture of the issue you're experiencing with your 3D printer?

WARNING: This response is AI generated and may contain errors.

[flat lantern]

BL A1 on all default .2mm settings on orca

[wind quiver]

did u change any settings between the first one and second one?

[flat lantern]

Nope exactly the same

[wind quiver]

which printer is this

[flat lantern]

Bambu Lab A1

[wind quiver]

never seen this issue on a bambulab printer

recalibrate then start a new print

if that also fails

[earnest mortar]

clean your build plate with dish soap and water

[wind quiver]

it printed successfully on one side of the plate

i dont see why it hasnt on the other side

[earnest mortar]

well that side is probably dirty

[flat lantern]

sorry i did skip it once i realised 15ish into the hour print

[flat lantern]

will do I usually recalibrate it when I move it somewhere

it doesn't happen too often only when theres a decent amount on the build plate

[wind quiver]

this isnt close to a decent amount

[flat lantern]

yeah fair, weird

[wind quiver]

what filament ru using

is this standard bambulab pla?

[wind quiver]

also have you tried this?

[flat lantern]

black creality ender pla, and red esun pla plus

[flat lantern]

not yet

[wind quiver]

have u made the correct settings for each pla?

there are slight differences in pla and pla+

[flat lantern]

yes used generic pla for ender pla

[wind quiver]

from what i can tell the problem started when us tarted printing in pla+

[wind quiver]

^

[flat lantern]

im using the esun pla+ preset

[wind quiver]

huh

have u tried a new print yet?

[flat lantern]

inside orca and bl studio it has a pla+ preset thing

[flat lantern]

yeah printing fine

happens every 1 in 5 prints

[wind quiver]

whats ur print speed, and how ru stabilizing the printer on ur desk