#Flow

1 messages · Page 1 of 1 (latest)

fresh hornetBOT
#
AI Help

It sounds like you may be experiencing flow rate issues in your slicer settings. Check for the extrusion multiplier or flow rate settings in your slicer software. Adjusting this setting can help regulate the amount of filament being extruded. If you're unable to locate the setting or need further assistance, you can refer to the user manual or contact the software support for specific guidance.

WARNING: This response is AI generated and may contain errors.
marsh flicker
#

can you check if you have wipe while extruding on? or scarf seam?

burnt lodge
#

I have scarf seam

#

But the seam is nowhere near it

burnt lodge
marsh flicker
#

then im not sure, can you send me the profile so i could mess with it?

burnt lodge
marsh flicker
#

then choose Printer config bundle

burnt lodge
#

i think this is it

#

my bad

burnt lodge
marsh flicker
#

did you uhh, check one of the printer?

#

like this

image.png
burnt lodge
#

yeah

burnt lodge
marsh flicker
#

i tried importing it, but it didnt work, maybe you could try importing it to your own orcaslicer, see if it works

#

but i think i got ur profile through the 3MF file you sent previously so its fine

#

scarf seams is the issue

#

turning that off fixed it

#

@burnt lodge

burnt lodge
fresh hornetBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.